Differences

This shows you the differences between two versions of the page.

--- ikea_vindriktning_esphome [2023/08/15 19:21] – benoitb
+++ ikea_vindriktning_esphome [2023/08/18 08:54] (current) – benoitb
@@ Line 1: / Line 1: @@
 ====== Ikea Vindriktning, bme280, sgp40, wemos S2 mini ======
-L'idée est de faire un boitier de mesure de la qualité de l'air intégré facilement dans Home Assistant.
+The aim is to create an air quality measurement device that iseasily integrated into Home Assistant.
-Liste des courses:
+Shopping list:
-  * Ikea Vindriktning capteur de particules fines
+  * Ikea Vindriktning, PM2.5 sensor, case, LED, off-line controler
     * https://www.ikea.com/fr/fr/p/vindriktning-capteur-qualite-de-lair-70498242/
-  * Capteur de température, pression, humidité: bme280 version 3.3v
+  * Temperature, pressure, humidity sensor: bme280 3.3v version
-    * https://fr.aliexpress.com/item/32862421810.html?spm=a2g0o.order_list.order_list_main.5.5d425e5bfSLLJD&gatewayAdapt=glo2fra
+    * https://s.click.aliexpress.com/e/_mNFfu6I
-  * Capteur de pollution VOX: sgp40
+  * VOX pollution sensor: sgp40
-    * https://fr.aliexpress.com/item/4000004614708.html?spm=a2g0o.order_list.order_list_main.11.5d425e5bfSLLJD&gatewayAdapt=glo2fra
+    * https://s.click.aliexpress.com/e/_msVbfiE
   * ESP32-S2 mini
-    * https://fr.aliexpress.com/item/1005004344359250.html?spm=a2g0o.order_list.order_list_main.17.5d425e5bfSLLJD&gatewayAdapt=glo2fra
+    * https://s.click.aliexpress.com/e/_mOTHPQi
-  * Un peu de câble et de quoi souder
+  * Some cables and tools to solder
-Le schéma de connexion:
+Wiring schematic:
 {{::ikeahack-connection.png?nolink|}}
-Le code YAML pour ESPHome:
+Once soldered:
+{{::ikehack_components.jpg?nolink|}}
+Solder points on the IKA stock PCB:
+{{::ikehack_solderpads.jpg?nolink|}}
+Final installation:
+{{::ikehack_install.jpg?nolink|}}
+Comments:
+  * In green, the Wemos S2 Mini is just slotted there. It's a tight fit so it doesn't move. I placed it under the fan not to disturb airflow around the PM1006 sensor and avoid heating up the upper chamber. The aim is also not to influence the temperature measurement.
+  * In blue, I cut a piece of the plastic wall to let the cables pass.
+  * In red, I sticked the sensors on each side of the case as close as possible to the venting grill. I used 3M VHB double sided tape.
+YAML configuration for ESPHome:
 <code>
 esphome: